Teppis One Supply
Home
Contact
MX2200 loading instructions
  1. Open the bottom floorplate and remove any old labels, then install a fresh roll of labels.
  2. Feed the labels down from the top until about 6" protrudes out the bottom of the labeler, then close the floorplate.
  3. Then after you close the floorplate pull the labels back towards the handle of the gun until about 6" of labels are stripped off the backing paper. Snip the end to remove any addl. labels.
  4. Put the backing paper in the slot ( fig. 2) in front of where it is stamped "label". It will push in about 1 ", then sqeeze the handle several while pushing down on the backing paper until the slack is taken up and the gun starts ejecting labels.


[ 1 ] [ 2 ] [ 3 ]